Комутатор керований L3 GCOM S5650-28SM


Дана модель включена в Підмінний фонд

12 * 10/100/1000 Base-X SFP портів
12 * GE Combo портів, 2*10GE slot
16K MAC address
Швидкість пересилання – 95.2Mpps
Комутаційна матриця – 128Gbps
Максимальне енергоспоживання до 50W
Живлення AC або DC
Резервування живлення 1 + 1

 

S5650-28SM є комутатором з високою щільністю портів і всім необхідним набором функцій рівня L3.
Комутатор GCOM S5650-28SM має на борту 12 * 10/100 / 1000BaseX, 12 * GE Combo (підтримка 100 / 1000BaseX SFP або 100 / 1000BaseT) портів для організації АПЛІНК, а також підтримує 2 * 10GE слота.
Підтримує стекування і весь необхідний набір функцій для організації якісного сервісу, а так ож функцію діагностики кабелю, DDM і захист від статики. GCOM S5650-28SM використовує високопродуктивний процесор для забезпечення максимальної швидкості пересилання і створення ліній для NGBN (New Generation Backbone Network), має широкі можливості ACL, прив'язки IP + MAC + port і багато іншого.

КОМПЛЕКТАЦІЮ БЛОКІВ ЖИВЛЕННЯ (AC / DC) уточнювати У МЕНЕДЖЕРІВ.


Share it:

Основні характеристики:

Backplane capacity 128Gbps
Switching capacity 128Gbps
Packet forwarding  rate 95.2Mpps
Memory and storage 256MB DDR2 SDRAM Memory and 8MB Flash Memory
Redundancy design 1+1 hot-swap redundant power
Power supply AC:Input 90~260V,50~60Hz;
DC:Input -48V~-60V;
Power consumption Full-load ≤50W
Idle ≤15W
Outline dimensions 440mm×380mm×44mm
Weight (in maximum configuration) ≤6kg
Environmental Working temperature:0°C~60°C
Storage temperature:-40°C~70°C
Relative humidity:5%~95%,no condensing
Electromagnetic compatibility

Детальні характеристики:

L2 features MAC 16K MAC address
MAC Black Hole
Port MAC Limit
VLAN 4K VLAN entries
Port-based/MAC-based/IP subnet-based VLAN
Port-based QinQ and Selective QinQ (StackVLAN)
VLAN Swap and VLAN Remark
PVLAN to realize port isolation and saving public-vlan resources
GVRP
Spanning tree protocol IEEE 802.1D Spanning Tree Protocol (STP)
IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
IEEE 802.1s Multiple Spanning Tree Protocol instances (MSTP)
Remote loop detecting
Port Bi-directional bandwidth control
Static link aggregation and LACP(Link Aggregation Control Protocol)
Port mirroring and traffic mirroring
Security features User’s security Anti-ARP-spoofing
Anti-ARP-flooding
IP Source Guard create IP+VLAN+MAC+Port binding
Port Isolation
MAC address binds to port and port MAC address filtration
IEEE 802.1x and AAA/Radius authentication
Device security Anti-DOS attack(such as ARP,Synflood, Smurf, ICMP attack), ARP detection, worm and Msblaster worm attack
SSHv2 Secure Shell
SNMP v3 encrypted management
Security IP login through Telnet
Hierarchical management and password protection of users
Network security User-based MAC and ARP traffic examination
automatic ARP protection based on MAC address and ARP packet suppression or automatic user block of ARP traffic detection
Dynamic ARP table-based binding
IP+VLAN+MAC+Port binding
L2 to L7 ACL flow filtration mechanism on the 80 bytes of the head of user-defined packet
Port-based broadcast/multicast suppression and auto-shutdown risk port
URPF to prevent IP address counterfeit and attack
DHCP Option82 and PPPoE+ upload user’s physical location
DHCP snooping / IP source Guard / 802.1X / rich security features
Link protection such as dynamic link aggregation and Ethernet ring network
Plaintext authentication of OSPF、RIPv2 and BGPv4 packets and MD5 cryptograph authentication
IP routing IPv4 ARP Proxy
DHCP Relay
DHCP Server
Static route
RIPv1/v2
OSPFv2
BGPv4
ECMP
Strategy route
Route policy
IPv6 ICMPv6
ICMPv6 redirection
DHCPv6
ACLv6
OSPFv3
RIPng
BGP4+
Configured Tunnel
ISATAP
6to4 tunnel
IPv6 and IPv4 Tunnels
IPv6 and IPv4 dual stack
PLS L3VPN、MPLS L2VPN and VPLS
Service features ACL Standard and extended ACL
Time Range ACL
Packet filter providing filtering based on source/destination MAC address, source/destination IP address, port, protocol, VLAN, VLAN range, MAC address range, or invalid frame. System supports concurrent identification at most 50 service traffic
Packet filtration of L2~L7 even deep to 80 bytes of IP packet head
QoS Rate-limit to packet sending/receiving speed of port or self-defined flow and provide general flow monitor and two-speed tri-color monitor of self-defined flow
Priority remark to port or self-defined flow and provide 802.1P, DSCP priority and Remark
transmission of high-priority packets with various traffic classification and QoS flow control functions
CAR(Committed Access Rate)、Traffic Shaping and flow statistics
Packet mirror and redirection of interface and self-defined flow
Super queue scheduler based on port and self-defined flow. Each port/ flow supports 8 priority queues and scheduler of SP, WRR and SP+WRR.
Congestion avoid mechanism,including Tail-Drop and WRED
Multicast IGMPv1/v2/v3
IGMPv1/v2/v3 Snooping
IGMP Filter
MVR and cross VLAN multicast copy
IGMP Fast leave
IGMP Proxy
PIM-SM/PIM-DM/PIM-SSM
PIM-SMv6、PIM-DMv6、PIM-SSMv6
MLDv2/MLDv2 Snooping
Reliability Loop protection EAPS and GERP (recover-time<50ms)
Loopback-detection
Link protection FlexLink (recover-time<50ms)
RSTP/MSTP (recover-time<1s)
LACP (recover-time<10ms)
BFD
Device protection VRRP host backup
Double fault-tolerant backup of host program and configuration files
1+1 power hot backup
Strictly follow the relevant standards, and other mainstream manufacturers fully interoperability
Maintenance Network maintenance Telnet-based statistics
RFC3176 sFlow
LLDP
802.3ah Ethernet OAM
RFC 3164 BSD syslog Protocol
Ping and Traceroute
Device management Command-line interface(CLI), Console, Telnet and WEB configuration
System configuration with SNMPv1/v2/v3
RMON (Remote Monitoring)1/2/3/9 groups of MIB
NTP(Network Time Protocol)
GN.LinkⅡ Server
NGBNView network management
WEB-based network management
Ping and Traceroute

 

L3 GCOM S5650-28SM firmware

Download

Firmware

GCOM S5650-28SM configuration

Download

Configuration

GCOM S5650-28SM datasheet

Download

Datasheet